Volume and Volume Group Lifecycle

Everpure Cloud Azure Native

Audience
Public
Source Type
Documentation

The volume lifecycle covers the most common day-2 operations performed after a volume has been created and mounted to a workload. In the Azure VM use case, these operations typically include cloning a volume for reuse or testing, increasing volume size as application needs grow, and deleting volumes that are no longer needed.

Clone a Volume

Cloning can be useful when a copy of an existing volume is needed for a development, test, recovery, or validation workflow. The clone is created from an existing source volume and appears as a new volume resource in the same Volume Group.

  1. Open the source volume from the volume list within the Volume Group.

  2. Click Clone.

  3. Enter a name for the new cloned volume.

  4. Click Create.

After the clone request is submitted, the new volume will appear in the volume list. Provisioning may take a few minutes. During this time, the cloned volume can briefly remain in a transitional state before it becomes fully available.

Resize a Volume

Resizing can be used when the workload requires more capacity than was originally provisioned. Volume capacity can be increased, but it cannot be reduced.

  1. Open the volume from the volume list within the Volume Group.

  2. Click Edit.

  3. In the edit pane, enter the new Provisioned capacity.

  4. Click Save.

After the resize request is submitted, the change is applied to the volume resource. The updated capacity should then be reflected in the Azure portal. If the volume is already in use by a guest operating system, additional steps inside the operating system may still be required before the workload can use the newly available space.

Delete a Volume

A Volume is in a state of Soft delete for 3 days before it is fully deleted. This helps avoid permanent loss of volume and data in case of misuse or error. Despite the reversible nature of soft delete, it should still be done only after confirming that the volume is no longer required by the application or host. Before deletion, it is recommended to unmount the volume from the guest operating system and verify that no workload still depends on it.

  1. Open the volume that is to be removed.

  2. Click Soft delete.

  3. Confirm the soft deletion by clicking Delete when prompted.

After deletion is confirmed, the volume is marked inactive in the Volume Group list. If it is not visible immediately, click Add Filter and filter the list by Status and Inactive. The inactive (or soft deleted volume) can be accessed from this list of volumes and either restored or permanently deleted.

Clone a Volume Group

Create a copy of an existing volume group and all its volumes.

Soft Delete a Volume Group

The selected Volume group and the dependent resources will be soft deleted. It is possible to restore them later.

To restore a Soft Deleted Volume group, navigate to the Volume Groups menu and filter for "Inactive" Volume Groups.

Select the Volume group to be restored, open it by clicking on its name in the list, and click Restore. Alternatively, to delete the volume, click Purge.