Configure Lifecycle Rule

CloudSnap uses one lifecycle rule and it is auto-created once the bucket is initialized by the array. Therefore, the following step applies to the destination bucket "Bucket-2" only, the source bucket will be connected to the array the step after.

On your local machine or AWS CloudShell, Create a file offload_lifecycle.json and paste the following rule to it.

{
    "Rules": [
        {
            "ID": "AbortIncompleteMultipartUpload",
            "Filter": {},
            "Status": "Enabled",
            "AbortIncompleteMultipartUpload": {
                "DaysAfterInitiation": 1
            }
        }
    ]
}

Then use AWS CLI to create the lifecycle rule on the destination bucket. Make sure to replace the bucket name (highlighted in green below)

aws s3api put-bucket-lifecycle-configuration --bucket cbs-offload-us-bucket-2 --lifecycle-configuration file://offload_lifecycle.json 

Verify on AWS Console that the lifecycle rule is created.