Review the following 13 sample questions prior to taking an exam to gain a better understanding of the types of questions that will be presented on the exam.
These sample test questions are for informational purposes ONLY and are provided to give prospective candidates an idea about the format and type of questions that will appear on the actual examination. These items are not to be used to determine a candidate's readiness to test. It does not guarantee a pass or fail result.
|
Question 1: Which power cabling is required for FlashArray installations that use Titanium PSUs? |
|---|
|
A. C13 to C14 |
|
B. C19 to C20 |
|
C. C14 to C19 |
|
Question 2: What is the default service type for ETH0/ETH1 in a FlashArray//XR4 controller? |
|---|
|
A. Management |
|
B. Replication |
|
C. DirectFlash Shelf |
|
Question 3: What is the minimum number of IP addresses the customer should provide for use by management? |
|---|
|
A. 1 |
|
B. 2 |
|
C. 4 |
|
Question 4: What is the minimum number of 75TB modules that are required to be installed in a FlashArray//E Gen2 chassis? |
|---|
|
A. 20 |
|
B. 10 |
|
C. 14 |
|
Question 5: On a new install, which command should an Implementation Engineer run to determine where the Purity USB drive is installed? |
|---|
|
A. |
|
B. |
|
C. |
|
Question 6: What is the required rack space for a FlashArray//XL (in rack units)? |
|---|
|
A. 5u |
|
B. 4u |
|
C. 3u |
|
Question 7: Which slot should an Implementation Engineer install the SAS HBA during an upgrade to a FlashArray//XR4? |
|---|
|
A. Slot 0 |
|
B. Slot 1 |
|
C. Slot 3 |
|
Question 8: What is the difference between a DFM and a DFMD? |
|---|
|
A. DFMD is direct access |
|
B. DFMD has higher density |
|
C. DFMD has onboard NVRAM |
|
Question 9: Which command should an Implementation Engineer run to verify data pack layout live on a given FlashArray? |
|---|
|
A. |
|
B. |
|
C. |
|
Question 10: What is the maximum array capacity of a Flasharray//X50R4? |
|---|
|
A. 94TB |
|
B. 185TB |
|
C. 256TB |
|
Question 11: An Implementation Engineer has completed a FlashArray install. Which command should the Implementation Engineer run to test network connectivity using a specific array Ethernet port? |
|---|
|
A. |
|
B. |
|
C. |
|
Question 12: Which type of solution is provided by SafeMode functionality? |
|---|
|
A. Intrusion-prevention |
|
B. Ransomware-recovery |
|
C. Data-protection |
|
Question 13: Upon installation of a new DirectFlash Shelf to a FlashArray//XL, the Implementation Engineer sees [X] on the rear LED panel of both storage controllers. What action should the Implementation Engineer take to remedy this situation? |
|---|
|
A. Run |
|
B. Set the shelf ID via the Health section of the array GUI |
|
C. Adjust cabling between the array and the shelf |