For each virtual distributed switch, you must add a port group for each iSCSI VLAN. For the FlashArray there will be two iSCSI VLANs, as can be seen in the below image there are indeed two, one with VLAN ID 1016 and 1017.
|
|
To create them, go to the Networking view in the inventory list and right click on the the desired VDS (Virtual Distributed Switch) and choose New Distributed Port Group.
|
|
Enter in a name for the port group that is clear and click Next. Choose VLAN under VLAN type and enter in the first VLAN ID.
|
|
|
Click Customize default policies configuration.
|
|
Under Teaming and failover change the load balancing to Route based on source MAC hash and also ensure the LAG is the Active uplink and the standard uplinks are moved to unused.
|
|
Complete the wizard. Now run the same process for the second VLAN.
|
|
Note, if your FlashArray uses jumbo frames (MTU is set to 9000) you must set this on the VDS as well. Right-click on the VDS and choose Settings > Edit Settings.
|
|
Under Advanced, change the MTU to 9000 and click OK.
|
|